Bushings & Sleeves
Plain, flanged and sleeve bushings for wear surfaces and pivot joints.
Bushings provide a replaceable wear surface in a lug or housing. Plain and flanged types are listed with their part numbers; installation is normally by press or shrink fit, with the interference set by the drawing.
Typical range
| Types | Plain, flanged, sleeve |
| Bore | 1/8 in to 4 in |
| Materials | Bronze, steel, CRES, composite |
| Lubrication | Oil-impregnated, greased, dry |
| Wall | Thin wall to heavy wall per part number |
| Standards | MS, NAS, AN |
How to choose
- Press or shrink fit is normal; the interference is set by the drawing.
- Flanged bushings take axial location as well as radial load.
- Oil-impregnated bronze for maintenance-free oscillating joints.
- Check the installed ID after pressing — it closes up with interference.
Compared with adjacent categories
A bushing is a replaceable wear surface in a lug or housing; a bearing adds rolling elements. Bushings are cheaper and quieter but limited in speed and load.
Questions buyers ask
Does the bore change after installation?
Yes. Pressing a bushing compresses it, so the finished bore is smaller than the free bore. The drawing specifies the installed dimension.
When should I use a flanged bushing?
When the joint also needs axial location or a thrust face, not just a radial wear surface.
Related categories
- Clamps — 1,839 part numbers
- Fittings & Adapters — 704 part numbers
- Gaskets & Seals — 464 part numbers
- Hinges — 47 part numbers
- Inserts — 188 part numbers
Send a part number. Get a quotation.
Quantity, condition and documentation confirmed in writing. No prices are published; every line is quoted.