CR Series
Cherry rivets and blind fasteners for airframe assembly.
CR part numbers identify blind rivets by type, diameter and grip. The installation tooling is specific to the family; confirm the grip range against the material stack before ordering.
Typical range
| Prefix | CR |
| Type | Cherry blind rivets |
| Dash code | Diameter and grip |
| Materials | Aluminium, monel, CRES, alloy steel |
| Installation | Pull tool to the family specification |
| Coverage | 1,098 numbers in this catalogue |
How to choose
- Use blind rivets where only one side of the joint is accessible.
- Match the grip range to the stack; a short rivet will not form a proper tail.
- Check the hole size — blind rivets are sensitive to hole tolerance.
- Use the specified pull tool; a generic tool can under-set the rivet.
Compared with adjacent families
CR covers Cherry blind rivets; HL covers Hi-Lok pins and collars, which are preloaded structural fasteners. Both are permanent, but they are installed differently and are not interchangeable.
Questions buyers ask
What does the CR number tell me?
The type of blind rivet, its diameter and its grip range. The dash number and the letter code carry that information.
Can a Cherry rivet replace a solid rivet?
Only where the drawing allows it. Shear and tensile values differ, and the hole preparation may differ too.
Why does the pull tool matter?
A blind rivet is set by pulling the mandrel to a controlled load. The wrong tool leaves the tail under-formed, which shows up as a loose joint.
Send a part number. Get a quotation.
Quantity, condition and documentation confirmed in writing. No prices are published; every line is quoted.