HL Series
Hi-Lok and Hi-Lite fasteners for high-strength airframe joints.
HL fasteners are installed with a controlled collar and require the matching tooling. The part number identifies the diameter and the grip; the collar is a separate part and should be quoted with the pin.
Typical range
| Prefix | HL |
| Type | Hi-Lok and Hi-Lite pins and collars |
| Dash code | Diameter and grip |
| Materials | Alloy steel, titanium, CRES |
| Finishes | Primer, anodise, dry film lubricant |
| Coverage | 1,183 numbers in this catalogue |
How to choose
- Quote the pin and the collar together — they are separate part numbers.
- Grip must match the stack; the collar is selected with the pin.
- Use the matching installation tooling; torque is set by the collar, not by feel.
- Check the hole preparation and the interference fit called out on the drawing.
Compared with adjacent families
HL fasteners are permanent, high-strength joints installed with a collar; rivets form a tail and are not preloaded the same way. A Hi-Lok is not a rivet and cannot be installed with rivet tooling.
Questions buyers ask
Is the collar included with the pin?
No. Pin and collar are separate part numbers and are normally quoted together.
How is grip measured on a Hi-Lok?
Grip is the stack thickness the fastener is designed to clamp; the dash number encodes it. The collar takes up the remaining thread.
Can Hi-Lok fasteners be removed?
They can be drilled out, but they are intended as permanent joints. Reuse of the pin or collar is not permitted.
Send a part number. Get a quotation.
Quantity, condition and documentation confirmed in writing. No prices are published; every line is quoted.