MS · NAS · AN · BAC hardware · quotation on requestsales@fastenspec.com
FSFASTENSPECMILITARY STANDARD HARDWARE
CatalogueStandardsPart numbersAboutRequest a quote

MS25281F7

Loop Clamp

MS25281F7 — Loop Clamp product render

Datasheet — MS25281F7

MS25281F7 is a loop clamp in the MS Series family, catalogued under clamps. The prefix identifies the standard that governs the part; the suffix sets the size, length or finish defined by that drawing. It is quoted against the part number, quantity and any drawing or NSN reference.

Features

  • Hose, loop, cushion and P-clip families
  • Diameter and band width set by the part number
  • CRES, aluminium and nylon cushion options
  • Vibration and chafe protection
  • Band and locking inspection
  • Bulk packing for routing kits

Specification

MS25281F7 — part data
Part numberMS25281F7
DescriptionLoop Clamp
Standard familyMS Series
CategoryClamps
Prefix / seriesMS25281F7
Thread / sizeSet by the dash number on the controlling drawing
Material optionsCRES, aluminium, steel, nylon cushion
Finish optionsPassivation, anodise, zinc
NSNConfirmed on quotation
DocumentationC of C and material certificate on request
ConditionStated on quotation
PriceQuotation only

Part-level fields are confirmed against the controlling drawing. Options listed are category references, not a guarantee of availability for this number.

Applications

  • Hose and duct routing
  • Cable and harness support
  • Fluid line stand-off
  • Engine and accessory plumbing

Standards and documentation

Clamp part numbers set the diameter range and the cushion material. Confirm the hose OD and the routing loads; over-tightening damages both the clamp and the hose.

MS clamps · AN clamps

Questions buyers ask

How do I confirm the exact dimensions of MS25281F7?

The dash suffix sets the size, length or finish defined by the controlling standard. Send the drawing revision with the enquiry and we confirm the dimensions against it before quoting.

Can MS25281F7 be supplied in a different finish or material?

For clamps, the usual options are passivation, anodise, zinc. Alternatives that stay within the same standard can be quoted; anything outside it needs the drawing and engineering approval.

What documentation is available with MS25281F7?

Certificate of conformance and a mill material certificate are available with the quotation. Dimensional reports, first-article inspection and NSN confirmation can be added if the order requires them.

Related part numbers

Part numberDescriptionFamily
MS25281F6Loop ClampMS Series
MS25281F8Loop ClampMS Series
MS25281F5Loop ClampMS Series
MS25281R10Loop ClampMS Series
MS25281F4Loop ClampMS Series
MS25281R11Loop ClampMS Series
MS25281F3Loop ClampMS Series
MS25281R12Loop ClampMS Series
Part numbers and family data are reference information. Confirm dimensions, material and finish against the controlling drawing before use; the product illustration is representative of the part family, not a controlled drawing of this exact dash number.

Send a part number. Get a quotation.

Quantity, condition and documentation confirmed in writing. No prices are published; every line is quoted.

Request a quote