MS · NAS · AN · BAC hardware · quotation on requestsales@fastenspec.com
FSFASTENSPECMILITARY STANDARD HARDWARE
CatalogueStandardsPart numbersAboutRequest a quote
Reference Dash sizes

AN and NAS dash sizes

The dash number after a military part number is a nominal size in sixteenths of an inch. It is a starting point, not a thread specification — always confirm the thread and the tolerance class against the drawing.

On AN and many NAS part numbers the dash is the nominal diameter: -4 means 4/16 in, or 1/4 in. The same convention carries into fittings, where the dash describes the tube outside diameter rather than the thread. A -6 fitting therefore suits 3/8 in tube, even though its thread is larger than 3/8 in.

DashNominal inchApprox. metricTypical use
-21/8 in3.2 mmSmall screws, cotter pins
-33/16 in4.8 mmSmall bolts, pins
-41/4 in6.4 mmGeneral airframe hardware
-55/16 in7.9 mmLight structural joints
-63/8 in9.5 mmStructural bolts and fittings
-81/2 in12.7 mmPrimary structural joints
-105/8 in15.9 mmHeavy joints, engine mounts
-123/4 in19.1 mmHeavy structural hardware
-161 in25.4 mmLarge fittings and mounts
-201-1/4 in31.8 mmHeavy fittings
-241-1/2 in38.1 mmLarge pipe and tube fittings
-322 in50.8 mmLargest standard fittings

What the dash does not tell you

The dash does not define the thread class, the material or the finish. UN threads are graded 1A/2A/3A externally and 1B/2B/3B internally: class 3 is the tightest and is used where the joint must resist vibration or where a close fit is specified. A dash number alone cannot tell you which class applies — the drawing does.

It also does not define the grip length. On bolts and Hi-Lok pins the dash usually encodes the grip, but the convention differs between families, which is why the same dash can mean different things on an AN bolt and a NAS pin.

Using the table

Treat the inch and metric columns as nominal equivalents, not as interchangeable specifications. A 1/4 in AN bolt is not a 6.4 mm metric bolt: the thread form, the pitch and the tolerances are different. If the drawing is metric, quote a metric part number.

For the prefix conventions behind these numbers, see how to read a part number. For a specific size, browse the catalogue by category or search the number directly.

Send a part number. Get a quotation.

Quantity, condition and documentation confirmed in writing. No prices are published; every line is quoted.

Request a quote